MITSUBISHI EVOLUTION FINAL EDITION

Evo Final Edition specs

Grimmspeed Boost Control Solenoid. Install AMS gate and shifter BASE bushings (remove console) Install 55mm AGT turbo ​MAP manifold ​MAP recirc downpipe ​New 55mm turbo and housing ​New coolant lines, new oil feed and filter, reuse return line but install new oring from box. ​Use Stainless downpipe gasket and labeled hardware for turbo to manifold. Install Ti test pipe and new invida catback exhaust. Install AMS Intercooler and black piping + turbosmart bov. Install AMS intake and filter, use turbosmart 3” to 3” coupler to join turbo to 3” intake elbow Install new S2 camshafts + Springs and Retainers – The provided Tomei tool should allow doing this without doing a timing job as it should release the chain tension. However if a timing job is required, parts provided. Install and gap new plugs Replace *FOAT*-tastic plastic valve cover with OEM aluminum one, use stainless hex bolts provided instead of oem bolts. Install heat shield on exhaust cam sensor on back right of valve cover Install Hyundai metal power steering pump idler pully’s – replaces 2 plastic ones that fail. Install new acc belt Install ACT clutch kit Install upgraded AMS clutch master cylinder + line. Install Radium fuel sump – should come mostly drop in ready with walbro 450 pump already installed. Install ID1050x injectors with included pigtails FLUIDS: Oil – Amsoil 0w40 provided w/ filter Transmission – Redline MT-85 TransferCase – Redline 75w90 Main Rear Diff – Redline 75w90 AYC/ACD pump and AYC portion of rear diff – Synthetic ATF Coolant – aluminum grade eg Porsche or BMW blue stuff + 1 bottle additive (VP or Purple-Ice)

Carbon fiber steering wheel Carbon fiber interior panels AMS shift knob Final edition badge Full black with red stitching interior

Full Varis carbon fiber hood, body kit, wing and trunk. Carbon fiber window panels. Install JDM front crash beam as it has the tow hook threads.

Enkei NT03 Wheels Install Stoptech brake rotors and Ferodo pads Trim all brake shielding front and rear. Install stoptech brake lines - Use Endless RF650 fluid Install NEW front and rear hubs, press ARP wheel studs in. Install 4x new tires, use new provided 12x1.25 lugs, put the old lugs back in a box. 35psi all around. NOTE: 12x1.25 is the subi pitch, this was during covid so the Evo pitch of 12x1.5 was months on backorder. So unless you replace the studs again, get subi lugs. Corner balance and align. 200lbs driver, -2.9 front, -1.8 rear.

265/35/18R Falken race track tires.

Install MCS coil over Shocks + Vorshalg top hat camber plates. – Preferred setup is 550 front 600 rear on 6” all around. Install Front Sway bar (whiteline) Install front sway end links (whiteline) Install front Control arms (ssb) Install front whiteline tie rod ends Install SPL rear toe arms Install whiteline rear diff bushings – side mounts and rear mount. Install TS drive shaft bushings Install TS under hood shifter bushings

The 2015 Mitsubishi Lancer Evolution Final Edition has a 710W Rockford Fosgate premium sound system with nine speakers, including a 10-inch subwoofer. The system includes: DTS Neural Surround, Premidia-Wide Surround, Dolby Volume, and Punch Control

West State Motorsports from Washington State. Forced Induction Performance.

Top 50 at Rix Magazine Tokyo 2.0